EMC Celerra data source

The Celerra (SSH) data source collects inventory information from Celerra storage. For configuration, this data source requires the IP address of the storage processors and a read-only user name and password.

Terminology

OnCommand Insight acquires the following inventory information from the EMC Celerra data source. For each asset type acquired by Insight, the most common terminology used for this asset is shown. When viewing or troubleshooting this data source, keep the following terminology in mind:

Vendor/Model Term Insight Term
Celerra Network Server Storage
Celerra Meta Volume / Celerra Storage Pool Storage Pool
File System Internal Volume
Data Mover Controller
File System mounted on a data Mover File Share
CIFS and NFS Exports Share
Disk Volume Backend LUN
Note: These are common terminology mappings only and might not represent every case for this data source.

Requirements

Configuration

Field Description
Address of Celerra IP address or fully-qualified domain name of the Celerra device
User Name Name used to log in to the Celerra device
Password Password used to log in to the Celerra device

Advanced configuration

Field Description
Inventory Poll Interval (minutes) Interval between inventory polls (default 20 minutes)
SSH Process Wait Timeout (sec) SSH process timeout (default 600 seconds)
Number of Retries Number of inventory retry attempts
SSH Banner Wait Timeout (sec) SSH banner wait timeout (default 20 seconds)