Skip to main content
OnCommand Insight

NetApp E-Series data source

Contributors

The NetApp E-Series data source collects inventory and performance information. There are two possible configurations (firmware 6.x and firmware 7.x+), and they both have the same values.

Terminology

OnCommand Insight acquires the following inventory information from the NetApp E-Series data source. For each asset type acquired by Insight, the most common terminology used for this asset is shown. When viewing or troubleshooting this data source, keep the following terminology in mind:

Vendor/Model Term

Insight Term

Drive

Disk

Volume Group

Disk Group

Storage Array

Storage

Controller

Storage Node

Volume Group

Storage Pool

Volume

Volume

Note

These are common terminology mappings only and might not represent every case for this data source.

Requirements

  • The IP address of each controller on the array

  • Port requirement 2463

Configuration

Field

Description

Comma-separated list of Array SANtricity Controller IPs

IP addresses and/or fully-qualified domain names for the array controllers

Advanced configuration

Field

Description

Inventory Poll Interval (min)

Interval between inventory polls (default 30 minutes)

Performance Poll Interval (up to 3600 seconds)

Interval between performance polls (default 300 seconds)