Configuring the number of hours to ignore dynamic data

You can configure the number of hours during which OnCommand Insight ignores updating dynamic data, such as used capacity. If the default of six hours is used and no configuration changes occur, reports will not be updated with dynamic data until after the default number of hours. This option improves performance because this option defers updates when only the dynamic data changes.

About this task

If a value is set for this option, OnCommand Insight will update dynamic data based on the following rules:

Dynamic data impacted by this option includes the following:

Steps

  1. On the Insight toolbar, click Admin and select Troubleshooting.
  2. At the bottom of the page in the Other tasks area, click the Advanced Troubleshooting link.
  3. Click the Advanced settings tab, in the Acquisition Dynamic Attributes section enter the number of hours that OnCommand Insight should ignore dynamic data for Acquisition Dynamic Attributes.
  4. Click Save .
  5. (Optional) To restart the acquisition unit, click the Restart Acquisition Unit link.
    Restating the local acquisition unit reloads all of the OnCommand Insight data source views. This change is applied during the next poll, so you do not have to restart the Acquisition Unit.