Modify MTU setting for interface group ports
Suggest changes
-
PDF of this doc site
- Cluster administration
-
Volume administration
- Logical storage management with the CLI
-
NAS storage management
- Configure NFS with the CLI
- Manage NFS with the CLI
-
Manage SMB with the CLI
- Manage file access using SMB
- SAN storage management
- Security and data encryption
-
Data protection and disaster recovery
- Data protection with the CLI
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
To modify the MTU setting for interface groups, you must modify the MTU of the broadcast domain.
VLAN MTU size should match the broadcast domain MTU of the underlying interface groups and physical ports. If a different VLAN setting is needed for a VLAN, it must not exceed the size specified by the underlying broadcast domain.
Steps
-
Modify the broadcast domain settings:
broadcast-domain modify -broadcast-domain broadcast_domain_name -mtu mtu_setting
The following warning message is displayed:
Warning: Changing broadcast domain settings will cause a momentary data-serving interruption. Do you want to continue? {y|n}: y
-
Enter y to continue.
-
Verify that the MTU setting were modified correctly:
network port show
network port show (network port show) Node: vsim-01 Ignore Speed(Mbps) Health Health Port IPspace Broadcast Domain Link MTU Admin/Oper Status Status ---- ------- ---------------- ---- ---- ----------- -------- ------ a0a Default Default-1 up 1300 auto/1000 healthy false e0a Default Default-1 up 1300 auto/1000 healthy false e0b Default Default up 1500 auto/1000 healthy false e0c Default Default up 1500 auto/1000 healthy false e0d Default Default up 1500 auto/1000 healthy false 5 entries were displayed.