Configure failover settings on a LIF
-
PDF of this doc site
-
Cluster administration
-
Volume administration
-
Logical storage management with the CLI
-
-
NAS storage management
-
Configure NFS with the CLI
-
Manage NFS with the CLI
-
Manage SMB with the CLI
-
Manage file access using SMB
-
-
-
Security and data encryption
-
Data protection and disaster recovery
-
![](https://docs.netapp.com/common/images/pdf-zip.png)
Collection of separate PDF docs
Creating your file...
You can configure a LIF to fail over to a specific group of network ports by applying a failover policy and a failover group to the LIF. You can also disable a LIF from failing over to another port.
-
When a LIF is created, LIF failover is enabled by default, and the list of available target ports is determined by the default failover group and failover policy based on the LIF type and service policy.
Beginning with 9.5, you can specify a service policy for the LIF that defines which network services can use the LIF. Some network services impose failover restrictions on a LIF.
If a LIF's service policy is changed in a way that further restricts failover, the LIF's failover policy is automatically updated by the system. -
You can modify the failover behavior of LIFs by specifying values for the -failover-group and -failover-policy parameters in the network interface modify command.
-
Modification of a LIF that results in the LIF having no valid failover target results in a warning message.
If a LIF that does not have a valid failover target attempts to fail over, an outage might occur.
-
Beginning with ONTAP 9.11.1, on All-Flash SAN Array (ASA) platforms, iSCSI LIF failover is automatically enabled on newly created iSCSI LIFs on newly created storage VMs.
Additionally, you can manually enable iSCSI LIF failover on pre-existing iSCSI LIFs, meaning LIFs that were created prior to upgrading to ONTAP 9.11.1 or later.
-
The following list describes how the -failover-policy setting affects the target ports that are selected from the failover group:
|
For iSCSI LIF failover, only the failover policies local-only , sfo-partner-only and disabled are supported.
|
-
broadcast-domain-wide
applies to all ports on all nodes in the failover group. -
system-defined
applies to only those ports on the LIF's home node and one other node in the cluster, typically a non- SFO partner, if it exists. -
local-only
applies to only those ports on the LIF's home node. -
sfo-partner-only
applies to only those ports on the LIF's home node and its SFO partner. -
disabled
indicates the LIF is not configured for failover.
Configure failover settings for an existing interface:
network interface modify -vserver <vserver_name> -lif <lif_name> -failover-policy <failover_policy> -failover-group <failover_group>
Examples of configuring failover settings and disabling failover
The following command sets the failover policy to broadcast-domain-wide and uses the ports in failover group fg3 as failover targets for LIF data1 on SVM vs3:
network interface modify -vserver vs3 -lif data1 -failover-policy broadcast-domain-wide -failover-group fg3 network interface show -vserver vs3 -lif * -fields failover-group,failover-policy vserver lif failover-policy failover-group ------- -------------- --------------- -------------- vs3 data1 broadcast-domain-wide fg3
The following command disables failover for LIF data1 on SVM vs3:
network interface modify -vserver vs3 -lif data1 -failover-policy disabled