Skip to main content

ONTAP commands for BMC management

Contributors

These ONTAP commands are supported on the Baseboard Management Controller (BMC).

The BMC uses some of the same commands as the Service Processor (SP). The following SP commands are supported on the BMC.

If you want to…​ Use this command

Display the BMC information

system service-processor show

Display/modify the BMC network configuration

system service-processor network show/modify

Reset the BMC

system service-processor reboot-sp

Display/modify the details of the currently installed BMC firmware image

system service-processor image show/modify

Update BMC firmware

system service-processor image update

Display the status for the latest BMC firmware update

system service-processor image update-progress show

Enable the automatic network configuration for the BMC to use an IPv4 or IPv6 address on the specified subnet

system service-processor network auto-configuration enable

Disable the automatic network configuration for an IPv4 or IPv6 address on the subnet specified for the BMC

system service-processor network auto-configuration disable

Display the BMC automatic network configuration

system service-processor network auto-configuration show

For commands that are not supported by the BMC firmware, the following error message is returned.

::> Error: Command not supported on this platform.