Skip to main content
ONTAP MetroCluster

Healing the configuration in a MetroCluster IP configuration (ONTAP 9.4 and earlier)

Contributors netapp-ahibbard netapp-ranuk NetAppZacharyWambold

You must heal the aggregates in preparation for the switchback operation.

Note On MetroCluster IP systems running ONTAP 9.5, healing is performed automatically, and you can skip these tasks.

The following conditions must exist before performing the healing procedure:

  • Switchover must have been performed and the surviving site must be serving data.

  • Storage shelves at the disaster site must be powered up, functional, and accessible.

  • ISLs must be up and operating.

  • Nodes in the surviving site must not be in HA failover state (both nodes must be up and running).

This task applies to MetroCluster IP configurations running ONTAP versions prior to 9.5 only.

This procedure differs from the healing procedure for MetroCluster FC configurations.

Steps
  1. Power up each controller module on the site that was switched over and let them fully boot.

    If the system displays the LOADER prompt, run the boot_ontap command.

  2. Perform the root aggregate healing phase: metrocluster heal root-aggregates

    cluster_A::> metrocluster heal root-aggregates
    [Job 137] Job succeeded: Heal Root-Aggregates is successful

    If the healing is vetoed, you have the option of reissuing the metrocluster heal root-aggregates command with the --override-vetoes parameter. If you use this optional parameter, the system overrides any soft vetoes that prevent the healing operation.

  3. Resynchronize the aggregates: metrocluster heal aggregates

    cluster_A::> metrocluster heal aggregates
    [Job 137] Job succeeded: Heal Aggregates is successful

    If the healing is vetoed, you have the option of reissuing the metrocluster heal command with the --override-vetoes parameter. If you use this optional parameter, the system overrides any soft vetoes that prevent the healing operation.

  4. Confirm the heal operation is complete by running the metrocluster operation show command on the healthy cluster:

    cluster_A::> metrocluster operation show
      Operation: heal-aggregates
          State: successful
     Start Time: 7/29/2017 20:54:41
       End Time: 7/29/2017 20:54:42
         Errors: -