Verifying and setting the HA state of the controller module

You must verify the HA state of the controller module and, if necessary, update the state to match your system configuration.

Steps

  1. In Maintenance mode from the new controller module, verify that all components display the same HA state: ha-config show
    If your system is in... The HA state for all components should be...
    An HA pair ha
    A stand-alone configuration non-ha
  2. If the displayed system state of the controller module does not match your system configuration, set the HA state for the controller module: ha-config modify controller ha-state
  3. If the displayed system state of the chassis does not match your system configuration, set the HA state for the chassis: ha-config modify chassis ha-state