Verifying and setting the HA state of the chassis

You must verify the HA state of the chassis, and, if necessary, update the state to match your system configuration.

Steps

  1. In Maintenance mode, from either controller module, display the HA state of the local controller module and chassis: ha-config show
    The HA state should be the same for all components.
  2. If the displayed system state for the chassis does not match your system configuration:
    1. Set the HA state for the chassis: ha-config modify chassis HA-state

      The value for HA-state can be one of the following:

      • ha
      • mcc
      • mcc-2n
      • mccip
      • non-ha
    2. Confirm that the setting has changed: ha-config show
  3. If you have not already done so, recable the rest of your system.
  4. The next step depends on your system configuration.
    If your system is in... Then...
    A stand-alone configuration
    1. Exit Maintenance mode: halt
    2. Go to "Completing the replacement process.
    An HA pair with a second controller module Exit Maintenance mode: halt

    The LOADER prompt appears.