Cabling the controllers to a single drive shelf

You must cable each controller to the NSM modules on the NS224 drive shelf.

About this task

Be sure to check the illustration arrow for the proper cable connector pull-tab orientation.



Note: As you insert the connector, you should feel it click into place; if you do not feel it click, remove it, turn it around and try again.

Steps

  1. You can use the animation or the step-by-step instructions to cable your controllers to a single shelf.


    Step Perform on each controller module
    Cable controller A to the shelf

    Cable controller B to the shelf:

  2. To complete setting up your system, see Completing system setup and configuration.