Cabling the controllers to two drive shelves

You must cable each controller to the NSM modules on both NS224 drive shelves.

About this task

Be sure to check the illustration arrow for the proper cable connector pull-tab orientation.



Note: As you insert the connector, you should feel it click into place; if you do not feel it click, remove it, turn it around and try again.

Steps

  1. You can use the following animation or the written steps to cable your controllers to two drive shelves.
    Step Perform on each controller module
    Cable controller A to the shelves:

    Cable controller B to the shelves:

  2. To complete setting up your system, see Completing system setup and configuration.