Removing the controller module

You must remove the controller module from the chassis when you replace the controller module or replace a component inside the controller module.

Steps

  1. If you are not already grounded, properly ground yourself.
  2. Unplug the controller module power supply from the source, and then unplug the cable from the power supply.
  3. Loosen the hook and loop strap binding the cables to the cable management device, and then unplug the system cables and SFPs (if needed) from the controller module, keeping track of where the cables were connected.
    Leave the cables in the cable management device so that when you reinstall the cable management device, the cables are organized.
  4. Remove the cable management device from the controller module and set it aside.
  5. Press down on both of the locking latches, and then rotate both latches downward at the same time.
    The controller moves slightly out of the chassis.


    Locking latch
    Locking pin
  6. Slide the controller module out of the chassis.
    Make sure that you support the bottom of the controller module as you slide it out of the chassis.
  7. Set the controller module aside in a safe place.