Cabling to a 10GbE host network

10GbE ports on the controllers are connected to 10GbE host network switches.

Before you begin

You must have contacted your network administrator for information about connecting the system to the switches.

About this task

Be sure to check the illustration arrow for the proper cable connector pull-tab orientation.

Note: As you insert the connector, you should feel it click into place; if you do not feel it click, remove it, turn it around and try again.
Step Perform on each controller module
1 Cable ports e4a through e4d to the 10GbE host network switches.

2 To perform other optional cabling, choose from:
3 To complete setting up your system, see Completing system setup and configuration