Moving internal drives from an original node

If your original node is one of the supported models, during the process of upgrading by moving storage you can move the node's internal SATA drives or SSDs to a drive shelf that is attached to the new node in the same cluster. You cannot transfer SAS drives to a drive shelf attached to the new nodes.

Before you begin

Steps

  1. Gently remove the bezel from the front of the system.
  2. Press the release button on the left side of the drive carrier.
    The following illustration shows a drive with the release button located on the left of the carrier face:

    The cam handle on the carrier partially springs open, and the carrier releases from the midplane.
  3. Pull the cam handle to its fully open position to unseat the carrier from the midplane, and then gently slide the carrier out of the drive shelf.
    Attention: Always use two hands when removing, installing, or carrying a drive. However, do not place your hands on the drive boards exposed on the underside of the carrier.

    The following illustration shows a carrier with the cam handle in its fully open position:



  4. With the cam handle in the open position, insert the carrier into a slot in the new drive shelf, firmly pushing until the carrier stops.
    Attention: Use two hands when inserting the carrier.
  5. Close the cam handle so that the carrier is fully seated in the midplane and the handle clicks into place.
    You should close the handle slowly so that it aligns correctly with the face of the carrier.
  6. Repeat Step 2 through Step 5 for all of the drives that you are moving to the new system.