Volume pairing warnings

You can view warning messages after you pair volumes on the Volume Pairs page of the Protection tab from the NetApp Element Management configuration point. These messages are displayed in the Volume Status column and can display on both source and target ends of the pairing.

These messages can display on both source and target ends of the pairing unless otherwise indicated.

PausedClusterFull
Because the target cluster is full, source replication and bulk data transfer cannot proceed. The message displays on the source end of the pair only.
PausedExceededMaxSnapshotCount
The target volume already has the maximum number of snapshots and cannot replicate additional snapshots.
PausedManual
Local volume has been manually paused. It must be unpaused before replication resumes.
PausedManualRemote
Remote volume is in manual paused mode. Manual intervention required to unpause the remote volume before replication resumes.
PausedMisconfigured
Waiting for an active source and target. Manual intervention required to resume replication.
PausedQoS
Target QoS could not sustain incoming IO. Replication auto-resumes. The message displays on the source end of the pair only.
PausedSlowLink
Slow link detected and stopped replication. Replication auto-resumes. The message displays on the source end of the pair only.
PausedVolumeSizeMismatch
Target volume is smaller than the source volume.
PausedXCopy
A SCSI XCOPY command is being issued to a source volume. The command must complete before replication can resume. The message displays on the source end of the pair only.
StoppedMisconfigured
A permanent configuration error has been detected. The remote volume has been purged or unpaired. No corrective action is possible; a new pairing must be established.