Reviewing appliance network connections

Before installing the StorageGRID Webscale appliance, you should understand which networks can be connected to the appliance and how the ports on each controller are used.

StorageGRID Webscale appliance networks

When you deploy a StorageGRID Webscale appliance as a Storage Node in a StorageGRID Webscale grid, you can connect it to the following networks:
  • Grid Network for StorageGRID Webscale: The Grid Network is used for all internal StorageGRID Webscale traffic. It provides connectivity between all nodes in the grid, across all sites and subnets. The Grid Network is required.
  • Admin Network for StorageGRID Webscale: The Admin Network is a closed network used for system administration and maintenance. The Admin Network is typically a private network and does not need to be routable between sites. The Admin Network is optional.
  • Client Network for StorageGRID Webscale: The Client Network is an open network used to provide access to client applications, including S3 and Swift. The Client Network provides client protocol access to the grid, so the Grid Network can be isolated and secured. The Client Network is optional.
  • Management network for SANtricity System Manager: This network provides access to SANtricity System Manager on the E2800 controller, allowing you to monitor and manage the hardware components in the appliance. This management network can be the same as the Admin Network for StorageGRID Webscale, or it can be an independent management network.
Note: For detailed information about StorageGRID Webscale networks, see the installation instructions for your platform.

StorageGRID Webscale appliance connections

When you install a StorageGRID Webscale appliance, you must connect the two controllers to each other and to the required networks. The figure shows the two controllers in the SG5760, with the E2800 controller on the top and the E5700SG controller on the bottom. In the SG5712, the E2800 controller is to the left of the E5700SG controller.


Connections on SG5760 appliance
  Port Type of port Function
1 Two interconnect ports on each controller

16Gb/s FC optical SFP+

Connect the two controllers to each other.
2 Management port 1 on the E2800 controller 1-Gb (RJ-45) Ethernet Connects to the network where you access SANtricity System Manager. You can use the Admin Network for StorageGRID Webscale or an independent management network.
Management port 2 on the E2800 controller 1-Gb (RJ-45) Ethernet Reserved for technical support.
3 Management port 1 on the E5700SG controller 1-Gb (RJ-45) Ethernet Connects the E5700SG controller to the Admin Network for StorageGRID Webscale.
Management port 2 on the E5700SG controller 1-Gb (RJ-45) Ethernet Can be used to connect the E5700SG controller to a service laptop during installation, if a DHCP-assigned IP address is not available.
4 10/25-GbE ports 1-4 on the E5700SG controller 10-GbE or 25-GbE
Note: The SFP+ transceivers included with the appliance support 10-GbE link speeds. If you want to use 25-GbE link speeds for the four network ports, you must provide SFP28 transceivers.
Connect to the Grid Network and the Client Network for StorageGRID Webscale. See "10/25-GbE port connections for the E5700SG controller."