Manually remove source SVM after client cutover
Suggest changes
-
PDF of this doc site
- Cluster administration
-
Volume administration
- Logical storage management with the CLI
-
NAS storage management
- Configure NFS with the CLI
- Manage NFS with the CLI
-
Manage SMB with the CLI
- Manage file access using SMB
- Security and data encryption
-
Data protection and disaster recovery
- Data protection with the CLI
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
If you performed the SVM migration with source cleanup disabled, you can remove the source SVM manually after client cutover is complete.
Steps
-
Verify they status is ready for source cleanup:
dest_cluster> vserver migrate show
-
Clean up the source:
dest_cluster> vserver migrate source-cleanup -vserver <vserver_name>