Example 1: 1-to-1 mapping to physical or virtual NICs
-
PDF of this doc site
- Install and upgrade software
-
Install and maintain hardware
- SG5700 storage appliances
- SG5600 storage appliances
-
Configure and manage
- Administer StorageGRID
- Use StorageGRID
-
Monitor and troubleshoot
- Monitor a StorageGRID system
Collection of separate PDF docs
Creating your file...
Example 1 describes a simple physical interface mapping that requires little or no host-side configuration.
The Linux operating system creates the ensXYZ
interfaces automatically during installation or boot, or when the interfaces are hot-added. No configuration is required other than ensuring that the interfaces are set to come up automatically after boot. You do have to determine which ensXYZ
corresponds to which StorageGRID network (Grid, Admin, or Client) so you can provide the correct mappings later in the configuration process.
Note that the figure show multiple StorageGRID nodes; however, you would normally use this configuration for single-node VMs.
If Switch 1 is a physical switch, you should configure the ports connected to interfaces 10G1 through 10G3 for access mode, and place them on the appropriate VLANs.