You must verify the HA state of the controller module and, if necessary, update the state to match your system configuration.
Steps
- In Maintenance mode from the new controller module, verify that all components display the same HA state: ha-config show
If your system is in... |
The HA state for all components should be... |
An HA pair |
ha |
A MetroCluster IP configuration |
mccip |
A stand-alone configuration |
non-ha |
- If the displayed system state of the controller module does not match your system configuration, set the HA state for the controller module: ha-config modify controller ha-state
- If the displayed system state of the chassis does not match your system configuration, set the HA state for the chassis: ha-config modify chassis ha-state