Install host interface card

You install a host interface card (HIC) to replace the failed one with a new HIC.

Before you begin

You have an ESD wristband, or you have taken other antistatic precautions.
You have a #1 Phillips screwdriver.
You have one or two HICs, based on whether you have one or two controllers in your storage array. The HICs must be compatible with your controllers.

About this task

Attention: Possible loss of data access – Never install a HIC in an E2800 controller canister if that HIC was designed for another E-Series controller. In addition, if you have a duplex configuration, both controllers and both HICs must be identical. The presence of incompatible or mismatched HICs will cause the controllers to lock down when you apply power.

Steps

Unpack the new HIC and the new HIC faceplate.
Press the button on the cover of the controller canister, and slide the cover off.
Confirm that the green LED inside the controller (by the DIMMs) is off.
If this green LED is on, the controller is still using battery power. You must wait for this LED to go off before removing any components.

Internal Cache Active LED Battery
Using a #1 Phillips screwdriver, remove the four screws that attach the blank faceplate to the controller canister, and remove the faceplate.
Align the three thumbscrews on the HIC with the corresponding holes on the controller, and align the connector on the bottom of the HIC with the HIC interface connector on the controller card.
Be careful not to scratch or bump the components on the bottom of the HIC or on the top of the controller card.
Carefully lower the HIC into place, and seat the HIC connector by pressing gently on the HIC.
Attention: Possible equipment damage – Be very careful not to pinch the gold ribbon connector for the controller LEDs between the HIC and the thumbscrews.

Host interface card (HIC) Thumbscrews
Hand-tighten the HIC thumbscrews.
Do not use a screwdriver, or you might over-tighten the screws.
Using a #1 Phillips screwdriver, attach the new HIC faceplate to the controller canister with the four screws you removed previously.

After you finish

Go to Reinstall controller canister