Replace host interface card

You install a new host interface card (HIC) to replace the failed HIC with a new one.

Before you begin

You have an ESD wristband, or you have taken other antistatic precautions.
You have a #1 Phillips screwdriver.
You have HICs, that are compatible with your controllers.
You have removed the HIC that is being upgraded.

About this task

Attention: Possible loss of data access – Never install a HIC in an Ef300 or EF600 controller canister if that HIC was designed for another E-Series controller. In addition, if you have a duplex configuration, both controllers and both HICs must be identical. The presence of incompatible or mismatched HICs causes the controllers to lock down when you apply power.

Procedure

Unpack the new HIC and the new HIC faceplate.
Align the single thumbscrew on the HIC with the corresponding holes on the controller, and align the connector on the bottom of the HIC with the HIC interface connector on the controller card.
Be careful not to scratch or bump the components on the bottom of the HIC or on the top of the controller card.
Carefully lower the HIC into place, and seat the HIC connector by pressing gently on the HIC.
Attention: Possible equipment damage – Be very careful not to pinch the gold ribbon connector for the controller LEDs between the HIC and the thumbscrew.

Note: The image above is an example, the appearance of your HIC may differ.
Hand-tighten the HIC thumbscrew.
Do not use a screwdriver, or you might over tighten the screws.
Using a #1 Phillips screwdriver, attach the HIC faceplate you removed from the original HIC with the three screws.

After you finish

Go to Reinstall controller canister