The reset storageArray iserStatsBaseline command resets the iSER baseline to 0 for the storage array.
This command applies to any individual storage array, including the E2700, E5600, E2800, E5700, EF600 and EF300 arrays, as long as all SMcli packages are installed.
To execute this command on an E2800, E5700, EF600, or EF300 storage array, you must have the Storage Admin role.
reset storageArray iserStatsBaseline
None.
This command does not actually reset the raw counts maintained in the hardware and firmware. Instead, the firmware creates a snapshot of the current counter values and uses these values to report differences in the counts when the statistics are retrieved. The new baseline time is applied to both controllers so that the controller counts are synchronized with each other. If one controller resets without the other controller resetting, the counters are no longer synchronized. The client becomes aware that the controllers are not synchronized because the timestamp data reported along with the statistics is not the same for both controllers.
8.20
8.41 This command is deprecated.