Controller host port configuration commands

Create host port
The create hostPort command creates a new host port identification on a host bus adapter (HBA) or on a host channel adapter (HCA).
Create initiator
The create initiator command creates the initiator object.
Delete initiator
The delete initiator command deletes the initiator object.
Reset storage array host port statistics baseline
The reset storageArray hostPortStatisticsBaseline command resets the storage array host port statistics baseline.
Save storage array host port statistics
The save storageArray hostPortStatistics command saves the storage array host port statistics.
Set controller host port properties
The set controller hostPort command changes the network properties for the following types of host ports: iSCSI, iSER, NVMe over InfiniBand, and NVMe over RoCE. Property changes include IPv4 and IPv6 properties, port speed, and maximum frame payload.
Set initiator
The set initiator command updates the initiator object.
Set target properties
The set target command changes the properties for an iSCSI/iSER target, including authentication method and alias name.
Set iSCSI host port networking properties
The set controller iscsiHostPort command changes the network properties for a host port, including IPv4 and IPv6 properties, port speed, and maximum frame payload.
Set iSCSI initiator
The set iscsiInitiator command sets the attributes for an iSCSI initiator.
Show storage array unconfigured iSCSI initiators
The show storageArray unconfiguredIscsiInitiators command returns a list of initiators that have been detected by the storage array but are not yet configured into the storage array topology.
Show unconfigured initiators
The show storageArray unconfiguredInitiators command returns a list of initiators that have been detected by the storage array but are not yet configured into the storage array topology.

Parent topic: Array configuration commands