Update SNMP trap destination

The set snmpTrapDestination trapReceiverIP command turns on or turns off sending authentication failure messages for an SNMP trap destination. Failure occurs when the SNMP agent received a message from an SNMP manager, but the message contained an invalid community name.

Supported Arrays

This command applies to an individual E2800, E5700, EF600 or EF300 storage array. It does not operate on E2700 or E5600 storage arrays.

Roles

To execute this command on an E2800, E5700, EF600, or EF300 storage array, you must have the Storage Admin or Support Admin role.

Syntax

set snmpTrapDestination trapReceiverIP=ipAddress 
[communityName="communityName"] 
[sendAuthenticationFailureTraps=(TRUE | FALSE)]

Parameters

Parameter Description
trapReceiverIP The IP address of the SNMP manager to which you want to send trap messages.
communityName The name of the SNMP community for which you want to send trap messages.
sendAuthenticationFailureTraps This parameter turns on or turns off sending authentication failure messages to an SNMP manager. To send authentication failure messages, set the parameter to TRUE. To prevent sending authentication failure messages, set the parameter to FALSE. The default is TRUE.

Minimum firmware level

8.30