Configure communities and destinations for SNMP alerts

To configure Simple Network Management Protocol (SNMP) alerts, you must identify at least one server where the storage array's event monitor can send SNMP traps. The configuration requires a community name and IP address for the server.

Before you begin

About this task

This task describes how to identify the SNMP server for trap destinations, and then test your configuration.


  1. Select Settings > Alerts.
  2. Select the SNMP tab.
    If a community is not yet configured, the SNMP tab displays "Configure Communities."
  3. Select Configure Communities.
    The Configure Communities dialog box opens.
  4. In the Community Name field, enter one or more community strings for the network servers, and then click Save.
    The Alerts page displays "Add Trap Destinations."
  5. Select Add Trap Destinations.
    The Add Trap Destinations dialog box opens.
  6. Enter one or more trap destinations, select their associated community names, and then click Add.
    • Trap Destination – Enter an IPv4 or IPv6 address of the server running an SNMP service.
    • Community name – From the drop-down, select the community name for this trap destination. (If you defined only one community name, the name already appears in this field.)
    • Send Authentication Failure Trap – Select this option (the checkbox) if you want to alert the trap destination whenever an SNMP request is rejected because of an unrecognized community name.
    After you click Add, the trap destinations and associated community names appear in the SNMP tab of the Alerts page.
  7. To make sure a trap is valid, select a trap destination from the table, and then click Test Trap Destination to send a test trap to the configured address.


The event monitor sends SNMP traps to the server(s) whenever an alertable event occurs.