You can view warning messages after you pair volumes on the Volume Pairs page of the Protection tab from the NetApp Element Management configuration point. These messages are displayed in the Volume Status column and can display on both source and target ends of the pairing.
These messages can display on both source and target ends of the pairing unless otherwise indicated.
- PausedClusterFull
- Because the target cluster is full, source replication and bulk data transfer cannot proceed. The message displays on the source end of the pair only.
- PausedExceededMaxSnapshotCount
- The target volume already has the maximum number of snapshots and cannot replicate additional snapshots.
- PausedManual
- Local volume has been manually paused. It must be unpaused before replication resumes.
- PausedManualRemote
- Remote volume is in manual paused mode. Manual intervention required to unpause the remote volume before replication resumes.
- PausedMisconfigured
- Waiting for an active source and target. Manual intervention required to resume replication.
- PausedQoS
- Target QoS could not sustain incoming IO. Replication auto-resumes. The message displays on the source end of the pair only.
- PausedSlowLink
- Slow link detected and stopped replication. Replication auto-resumes. The message displays on the source end of the pair only.
- PausedVolumeSizeMismatch
- Target volume is smaller than the source volume.
- PausedXCopy
- A SCSI XCOPY command is being issued to a source volume. The command must complete before replication can resume. The message displays on the source end of the pair only.
- StoppedMisconfigured
- A permanent configuration error has been detected. The remote volume has been purged or unpaired. No corrective action is possible; a new pairing must be established.