Inventory Poll Interval (min) |
Interval between inventory polls (default 40 minutes)
|
SNMP Auth Protocol |
SNMP authentication protocol (SNMPv3 only) |
SNMP Privacy Protocol |
SNMP privacy protocol (SNMPv3 only) |
SNMP Privacy Password |
SNMP privacy password |
SNMP Retries |
Number of SNMP retry attempts |
SNMP Timeout (ms) |
SNMP timeout (default 5000 ms) |
Enable Trapping |
Select to enable trapping. If you enable trapping, you must also activate SNMP notifications. |
Minimum Time Between Traps (sec) |
Minimum time between acquisition attempts triggered by traps (default 10 seconds) |
Discover All Fabric Switches
|
Select to discover all switches in the fabric |
Exclude Devices |
Comma-separated list of device IPs to exclude from polling
|
Include Devices |
Comma-separated list of device IPs to include in polling |
Check Device Type |
Select to accept only those devices that explicitly advertise themselves as Cisco devices |
Primary Alias Type |
Provide a first preference for resolution of the alias. Choose from the following:- Device Alias
- This is a user-friendly name for a port WWN (pWWN) that can be used in all configuration commands, as required. All switches in the Cisco MDS 9000 Family support Distributed Device Alias Services (device aliases).
- None
- Do not report any alias
- Port Description
- A description to help identify the port in a list of ports
- Zone Alias (all)
- A user-friendly name for a port that can be used only for zoning configuration
- Zone Alias (only active)
- A user-friendly name for a port that can be used only for the active configuration. This is the default.
|
Secondary Alias Type |
Provide a second preference for resolution of the alias |
Tertiary Alias Type |
Provide a third preference for resolution of the alias |
Enable SANTap Proxy Mode Support |
Select if your Cisco switch is using SANTap in proxy mode. If you are using EMC RecoverPoint, then you are probably using SANTap. |
Performance Poll Interval (sec)
|
Interval between performance polls (default 300 seconds)
|