metrocluster check run

Check the MetroCluster setup

Availability: This command is available to cluster administrators at the admin privilege level.

Description

The metrocluster check run command performs checks on the MetroCluster configuration and reports configuration errors if any.

To run this command, at least one DR group needs to be configured. The command checks the following parts of the configuration:

Node Configuration: Aggregate Configuration:

At the end of the check the command displays a summary of the results. This summary output can be viewed again by running metrocluster check show. If any of the rows in this output show any warnings more details can be viewed by running the metrocluster check show command for that component.

Parameters

[-skip-dr-simulation {true|false}] - Skip the DR Readiness Checks (privilege: advanced)
If this optional parameter is set to true, the switchover and switchback simulations are not run.

Examples

The following example shows the execution of the command when there are no warnings:

        clusA::> metrocluster check run
	
        Last Checked On: 4/9/2014 20:11:46

        Component           Result
        ------------------- ---------
        nodes               ok
        clusters            ok
        lifs                ok
        config-replication  ok
        aggregates          ok
5 entries were displayed.

        Command completed. Use the "metrocluster check show -instance" command or sub-commands in "metrocluster check" directory for detailed results.

       

The following example shows the execution of the command when there are some warnings:

        clusA::> metrocluster check run

        Last Checked On: 4/9/2014 20:11:46

        Component           Result
        ------------------- ---------
        nodes               warning
        clusters            ok
        lifs                ok
        config-replication  ok
        aggregates          ok
5 entries were displayed.

        Command completed. Use the "metrocluster check show -instance" command or sub-commands in "metrocluster check" directory for detailed results.