Rename a node
Contributors
Suggest changes
-
PDF of this doc site
- Cluster administration
-
Volume administration
- Logical storage management with the CLI
-
NAS storage management
- Configure NFS with the CLI
- Manage NFS with the CLI
-
Manage SMB with the CLI
- Manage file access using SMB
- SAN storage management
- Security and data encryption
-
Data protection and disaster recovery
- Data protection with the CLI
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You can change a node's name as required.
Steps
-
To rename a node, use the
system node rename
command.The
-newname
parameter specifies the new name for the node. Thesystem node rename
man page describes the rules for specifying the node name.If you want to rename multiple nodes in the cluster, you must run the command for each node individually.
Node name cannot be “all” because “all” is a system reserved name.
Example of renaming a node
The following command renames node “node1” to “node1a”:
cluster1::> system node rename -node node1 -newname node1a