Commands for managing FC adapters

You can use FC commands to manage FC target adapters, FC initiator adapters, and onboard FC adapters for your storage controller. The same commands are used to manage FC adapters for the FC protocol and the FC-NVMe protocol.

FC initiator adapter commands work only at the node level. You must use the run -node node_name command before you can use the FC initiator adapter commands.

Commands for managing FC target adapters

If you want to... Use this command...
Display FC adapter information on a node network fcp adapter show
Modify FC target adapter parameters network fcp adapter modify
Display FC protocol traffic information run -node node_name sysstat -f
Display how long the FC protocol has been running run -node node_name uptime
Display adapter configuration and status run -node node_name sysconfig -v adapter
Verify which expansion cards are installed and whether there are any configuration errors run -node node_name sysconfig -ac
View a man page for a command man command_name

Commands for managing FC initiator adapters

If you want to... Use this command...
Display information for all initiators and their adapters in a node run -node node_name storage show adapter
Display adapter configuration and status run -node node_name sysconfig -v adapter
Verify which expansion cards are installed and whether there are any configuration errors run -node node_name sysconfig -ac

Commands for managing onboard FC adapters

If you want to... Use this command...
Display the status of the onboard FC ports run -node node_name system hardware unified-connect show