Skip to main content

Relocate root volumes to new aggregates

Contributors
PDFs

The root replacement procedure migrates the current root aggregate to another set of disks without disruption.

About this task

You can change the location of the root volume to a new aggregate in the following scenarios:

  • When the root aggregates are not on the disk you prefer

  • When you want to rearrange the disks connected to the node

  • When you are performing a shelf replacement of the EOS disk shelves

Steps

  1. Relocate the root aggregate:

    system node migrate-root -node node_name -disklist disk_list -raid-type raid_type

    • -node

      Specifies the node that owns the root aggregate that you want to migrate.

    • -disklist

      Specifies the list of disks on which the new root aggregate will be created. All disks must be spares and owned by the same node. The minimum number of disks required is dependent on the RAID type.

    • -raid-type

      Specifies the RAID type of the root aggregate. The default value is raid-dp. This is the only type supported in advanced mode.

  2. Monitor the progress of the job:

    job show -id jobid -instance

Results

If all of the pre-checks are successful, the command starts a root volume replacement job and exits.