Deleting TI zoning and configuring IOD settings

You must delete the existing TI zoning and reconfigure in-order-delivery (IOD) settings on the switch fabric.

1. Identify the TI zones that are configured on the fabric: zone –-show
   The following example shows the zone FCVI_TI_FAB_2.

   Brocade-6510:admin> zone --show
      Defined TI zone configuration:
      TI Zone Name:   FCVI_TI_FAB_2
      Port List:      1,0; 1,3; 2,0; 2,3
      configured Status: Activated / Failover-Disabled
      Enabled Status: Activated / Failover-Disabled
   
   

2. Delete the TI zones: zone -–delete zone-name
   The following example shows the deletion of zone FCVI_TI_FAB_2.

   Brocade-6510:admin> zone --delete FCVI_TI_FAB_2
   

3. Confirm that the zones have been deleted: zone –-show
   The output should be similar to the following:

   Brocade-6510:admin> zone -–show
   
       Defined TI zone configuration:
       no TI zone configuration defined
   
   

4. Save the configuration: cfgsave
5. Enable in-order-delivery: iodset
6. Select Advanced Performance Tuning (APT) policy 1, the Port Based Routing Policy: aptpolicy 1
7. Disable Dynamic Load Sharing (DLS): dlsreset
8. Verify the IOD settings using the following commands: iodshowaptpolicydlsshow
   The output should be similar to the following:

   Brocade-6510:admin> iodshow
   
   IOD is set
   
   Brocade-6510:admin> aptpolicy
    Current Policy: 1
   
    3 : Default Policy
    1: Port Based Routing Policy
    2: Device Based Routing Policy (FICON support only)
    3: Exchange Based Routing Policy
   Brocade-6510:admin> dlsshow
   
   DLS is not set