You must locate the boot media in the controller and follow the directions to replace it.
Procedure
- If you are not already grounded, properly ground yourself.
-
Locate the boot media using the following illustration or the FRU map on the controller module:
- Press the blue button on the boot media housing to release the boot media from its housing, and then gently pull it straight out of the boot media socket.
Note: Do not twist or pull the boot media straight up, because this could damage the socket or the boot media.
- Align the edges of the replacement boot media with the boot media socket, and then gently push it into the socket.
- Check the boot media to make sure that it is seated squarely and completely in the socket.
If necessary, remove the boot media and reseat it into the socket.
- Push the boot media down to engage the locking button on the boot media housing.
- Close the controller module cover.