You must cable each controller to the NSM modules on the NS224 drive shelves
on an AFF A700 or ASA AFF A700 running system ONTAP 9.8 or later.
About this task
- This task applies to AFF A700 and ASA AFF A700 running ONTAP 9.8 or later
only.
- The systems must have two X91148A modules, per controller,
installed in slots 3 and 7.
Be sure to check the illustration arrow for the proper cable
connector pull-tab orientation. The cable pull-tab for the storage modules
are up, while the pull tabs on the shelves are down.


Note: As you insert the connector, you should feel it click into place; if
you do not feel it click, remove it, turn it around and try
again.
Procedure
-
Use the following animation or diagram to cable your controllers to two NS224
drive shelves.
- To complete setting up your system, see Completing system setup and configuration.