If you have network discovery enabled on your laptop, you can complete system
setup and configuration using automatic cluster discovery.
Procedure
-
Use the following animation to set one or more drive shelf IDs:
If your system has NS224 drive
shelves, the shelves are pre-set to shelf ID 00 and 01. If you want to change
the shelf IDs, you must create a tool to insert into the hole where button is
located.
- Plug the
power cords into the controller power supplies, and then connect them to power
sources on different circuits.
- Turn on the power switches to both nodes.
Note: Initial booting may take up to eight
minutes.
- Make sure that your laptop has network discovery enabled.
See your laptop’s online help for more information.
- Use the following animation to connect your laptop to the Management switch.
- Select an ONTAP icon listed to discover:
-
Open File Explorer.
-
Click network in the left pane.
-
Right click and select refresh.
-
Double-click either ONTAP icon and accept any certificates displayed on
your screen.
Note: XXXXX is the system serial number for the target node.
System Manager opens.
-
Use System Manager guided setup to configure your
system using the data you collected in the NetApp ONTAP
Configuration Guide.
-
Set up your account and download Active IQ Config Advisor:
-
Log in to your existing account or create an account.
-
Register your system.
-
Download Active IQ Config Advisor.
- Verify the health of your system by running Config Advisor.
- After you have completed the initial configuration, go to the ONTAP & ONTAP System Manager Documentation Resources page for information about configuring additional features in ONTAP.