To replace the chassis, you must remove the controller modules from the old chassis.
About this task
You can use the following video or the tabulated steps to replace the chassis; it assumes the removal and replacement of the bezel:
Procedure
- If you are not already grounded, properly ground yourself.
- Unplug the controller module power supplies from the source.
- Release the power cable retainers, and then unplug the cables from the power supplies.
-
Insert your forefinger into the latching mechanism on either side of the controller module, press the lever with your thumb, and gently pull the controller a few inches out of the chassis.
Note: If you have difficulty removing the controller module, place your index fingers through the finger holes from the inside (by crossing your arms)
-
Using both hands, grasp the controller module sides and gently pull it out of the chassis and set it on a flat, stable surface.
-
Set the controller module aside in a safe place, and repeat these steps for the other controller module in the chassis.
