Cabling the controllers to SAS drive shelves

You must cable each controller to the IOM modules on both SAS drive shelves.

About this task

Be sure to check the illustration arrow for the proper cable connector pull-tab orientation. The cable pull-tab for the DS224-C are down.

Note: As you insert the connector, you should feel it click into place; if you do not feel it click, remove it, turn it around and try again.

1. Use the following animation to cable your controllers to two drive shelves.

   Cabling the controllers to SAS drive shelves

2. To complete setting up your system, see Completing system setup and configuration.