You need specific switch and controller documentation to set up your Cluster-Mode configuration.
To set up the BES-53248 cluster switch, you need the following documents available from the Broadcom Support Site: Broadcom Ethernet Switch Product Line
Document title | Description |
---|---|
EFOS Administrator’s Guide v3.4.3 | Provides examples of how to use the BES-53248 switch in a typical network. |
EFOS CLI Command Reference v3.4.3 | Describes the command-line interface (CLI) commands you use to view and configure the BES-53248 software. |
EFOS Getting Started Guide v3.4.3 | Provides detailed information about for the BES-53248 switch. |
EFOS SNMP Reference Guide v3.4.3 | Provides examples of how to use the BES-53248 switch in a typical network. |
EFOS Scaling Parameters and Values v3.4.3 | Describes the default scaling parameters with which EFOS software is delivered and validated on the supported platforms. |
EFOS Functional Specifications v3.4.3 | Describes the specifications for the EFOS software on the supported platforms. |
EFOS Release Notes v3.4.3 | Provides release-specific information about BES-53248 software. |
To set up an ONTAP system, you need the following documents from the NetApp Support Site at mysupport.netapp.com
Name | Description |
---|---|
Hardware Universe | Describes the power and site requirements for all NetApp hardware, including system cabinets. |
Controller-specific Installation and Setup Instructions | Describes how to install NetApp hardware. |
ONTAP 9 | Provides detailed information about all aspects of the ONTAP 9 release. |