You can configure nodes using the Node Configuration user interface.
About this task
- You can configure the node to have either an IPv4 or IPv6 address.
- You need the DHCP address displayed in the TUI to access a node. You cannot use DHCP addresses to add a node to a cluster.
Attention: You should configure the Bond1G and Bond10G interfaces for separate subnets. Bond1G and Bond10G interfaces configured for the same subnet causes routing problems when storage traffic is sent via the Bond1G interface. If you must use the same subnet for management and storage traffic, manually configure management traffic to use the Bond10G interface. You can do this for each node using the Cluster Settings page of the ElementNetApp Element software UI.
Steps
- In a browser window, enter the DHCP IP address of a node.
You must add the extension :442 to access the node; for example, https://172.25.103.6:442.
The Network Settings tab opens with the Network Settings – Bond1G section.
- Enter the 1G network settings.
- Click Save Changes.
- Click Bond10G to display the settings for the 10G network settings.
- Enter the 10G network settings.
- Click Save Changes.
- Click Cluster Settings.
- Enter the hostname for the 10G network.
- Click Save Changes.