Replacing a storage node in a SolidFire Cluster

You must replace a storage node in the event of CPU failure, Radian card problems, other motherboard issues, or if it does not power on. The instructions apply to H410S storage nodes.

Before you begin

About this task

Alarms in the NetApp Element Software UI alert you when a storage node fails. You must use the NetApp Element software UI to get the serial number (service tag) of the failed node. You need this information to locate the failed node in the cluster.
The following figure shows the back of a two rack unit (2U), four-node chassis with four storage nodes:
This figure shows the four-node chassis with four storage nodes.