Before deploying the StorageGRID Webscale appliance, you must gather information about Ethernet switch ports and IP addresses.
Information needed | Your value |
---|---|
Specify the Ethernet switch port you will connect to management port 1 on the E2700 controller (used to access the management network for SANtricity Storage Manager) | Switch port for management port 1 on E2700 controller: |
Specify the Ethernet switch port you will connect to management port 1 on the E5600SG controller (used to access the Admin network for StorageGRID Webscale) | Switch port for management port 1 on E5600SG controller: |
MAC addresses or IP addresses for management ports
|
Address for management port 1 on E2700 controller: |
Address for management port 1 on E5600SG controller: | |
Specify the switch ports you will connect to the four 10-GbE optical ports on the E5600SG controller. Note: If you plan to use Fixed Port Configuration, ports 2 and 4 connect to the Grid network for StorageGRID Webscale, and ports 1 and 3 connect to the Client network for StorageGRID Webscale. If you plan to use Aggregate Port Configuration, see information about StorageGRID Webscale appliance connections and cabling the appliance.
|
Switch port for Port 2: |
Switch port for Port 4: | |
Switch port for Port 1: | |
Switch port for Port 3: | |
Specify the IP address of the Grid network interface for StorageGRID Webscale. Note: This information might not be available at the time you are performing the hardware phase of the installation.
|
Grid network IP address: |
Specify the IP address of the Client network interface for StorageGRID Webscale. Note: This information might not be available at the time you are performing the hardware phase of the installation.
|
Client network IP address: |