Starting StorageGRID Webscale appliance installation

To install StorageGRID Webscale on an appliance Storage Node, you use the StorageGRID Webscale Appliance Installer, which is included on the appliance.

Before you begin

The appliance has been installed in a rack, connected to your networks, and powered on.
Network links and IP addresses have been configured for the appliance using the StorageGRID Webscale Appliance Installer.
You know the IP address of the primary Admin Node for the StorageGRID Webscale grid.
All Grid Network subnets listed on the IP Configuration page of the StorageGRID Webscale Appliance Installer have been defined in the Grid Network Subnet List on the primary Admin Node.

For instructions for completing these prerequisite tasks, see the Hardware Installation and Maintenance Guide for your appliance.

You have a service laptop with a supported web browser.
You know one of the IP addresses assigned to the E5600SG controller or the E5700SG controller. You can use the IP address for the Admin Network (management port 1 on the controller), the Grid Network, or the Client Network.
Note: The E5600SG controller is the compute controller for the SG5600 series appliances (SG5612 and SG5660). The E5700SG controller is the compute controller for SG5700 series appliances (SG5712 and SG5760).

About this task

To install StorageGRID Webscale on an appliance Storage Node:

You specify or confirm the IP address of the primary Admin Node and the name of the node.
You start the installation and wait as volumes are configured and the software is installed.
Partway through the process, the installation pauses. To resume the installation, you must sign into the Grid Management Interface and configure the pending Storage Node so that the grid recognizes it as a replacement for the failed node.
After you have configured the node, the appliance installation process completes, and the appliance is rebooted.

Steps

Open a browser, and enter one of the IP addresses for the E5600SG controller or the E5700SG controller.
http://Controller_IP:8080

The StorageGRID Webscale Appliance Installer Home page appears.
In the Primary Admin Node connection section, determine whether you need to specify the IP address for the primary Admin Node.
The StorageGRID Webscale Appliance Installer can discover this IP address automatically, assuming the primary Admin Node, or at least one other grid node with ADMIN_IP configured, is present on the same subnet.

If this IP address is not shown or you need to change it, specify the address:

Option	Description
Manual IP entry	Unselect the Enable Admin Node discovery check box. Enter the IP address manually. Click Save. Wait while the connection state for the new IP address becomes "ready."
Automatic discovery of all connected primary Admin Nodes	Select the Enable Admin Node discovery check box. From the list of discovered IP addresses, select the primary Admin Node for the grid where this appliance Storage Node will be deployed. Click Save. Wait while the connection state for the new IP address becomes "ready."

In the Node name field, enter the name you want to use for this Storage Node, and click Save.
The node name is assigned to this Storage Node in the StorageGRID Webscale system. It is shown on the Grid Nodes page in the Grid Management Interface.
In the Installation, section, confirm that the current state is "Ready to start installation of node name into grid with Primary Admin Node admin_ip" and that the Start Installation button is enabled.
If the Start Installation button is not enabled, you might need to change the network configuration or port settings. For instructions, see the Hardware Installation and Maintenance Guide for your appliance.
From the StorageGRID Webscale Appliance Installer home page, click Start Installation.

The Current state changes to "Installation is in progress," and the Monitor Installation page is displayed.

Note: If you need to access the Monitor Installation page manually, click Monitor Installation from the menu bar.