Replacing the E5700SG controller

You might need to replace the E5700SG controller if it is not functioning optimally or if it has failed.

Before you begin

About this task

The appliance Storage Node will not be accessible when you replace the controller. If the E5700SG controller is functioning sufficiently, you can perform a controlled shutdown at the start of this procedure.
Note: If you are replacing the controller before installing StorageGRID Webscale software, you might not be able to access the StorageGRID Webscale Appliance Installer immediately after completing this procedure. While you can access the StorageGRID Webscale Appliance Installer from other hosts on the same subnet as the appliance, you cannot access it from hosts on other subnets. This condition should resolve itself within 15 minutes (when any ARP cache entries for the original controller time out), or you can clear the condition immediately by purging any old ARP cache entries manually from the local router or gateway.

Steps

  1. If the E5700SG controller is functioning sufficiently to allow for a controlled shutdown, shut down the E5700SG controller.
    1. From the service laptop, log in to the grid node:
      1. Enter the following command: ssh admin@grid_node_IP
      2. Enter the password listed in the Passwords.txt file.
      3. Enter the following command to switch to root: su -
      4. Enter the password listed in the Passwords.txt file.
      When you are logged in as root, the prompt changes from $ to #.
    2. Stop all StorageGRID Webscale services:/etc/init.d/servermanager stop
    3. Shut down the E5700SG controller:shutdown -h now
    4. Wait for any data in cache memory to be written to the drives.
      The green Cache Active LED on the back of the E2800 controller is on when cached data needs to be written to the drives. You must wait for this LED to turn off.
  2. Turn off the power.
    1. From the home page of SANtricity System Manager, select View Operations in Progress.
    2. Confirm that all operations have completed.
    3. Turn off both power switches on the appliance.
    4. Wait for all LEDs to turn off.
  3. If the StorageGRID Webscale networks attached to the controller use DHCP servers:
    1. Note the MAC addresses for the ports on the replacement controller (located on labels on the controller).
    2. Ask your network administrator to update the IP address settings for the original controller to reflect the MAC addresses for the replacement controller.
      Attention: You must ensure that the IP addresses for the original controller have been updated before you apply power to the replacement controller. Otherwise, the controller will obtain new DHCP IP addresses when it boots up and might not be able to reconnect to StorageGRID Webscale. This step applies to all StorageGRID Webscale networks that are attached to the controller.
  4. Follow the instructions in the replacement procedure for the E5700SG controller to complete these steps:
    Note: The instructions for the E5700 controller describe how to remove the battery and the host interface card (HIC) from a failed controller and install them in a replacement controller. You can skip those steps—the E5700SG controller does not include a battery and the replacement controller should already include a HIC.
    1. Label the cables and then disconnect the cables and SFPs.
      Attention: To prevent degraded performance, do not twist, fold, pinch, or step on the cables.
    2. Remove the failed controller from the appliance.
    3. Install the replacement controller into the appliance.
    4. Replace the cables and SFPs.
    5. Power on the appliance and monitor the controller LEDs and seven-segment displays.
      After the controllers have successfully booted up, the seven-segment displays should show the following:
      • E2800 controller:

        The final state is 99.

      • E5700SG controller:

        The final state is HA.

  5. Confirm that the appliance Storage Node appears in the Grid Management Interface and that no alarms appear.