Starting StorageGRID appliance installation

To install StorageGRID on an appliance Storage Node, you use the StorageGRID Appliance Installer, which is included on the appliance.

Before you begin

The appliance has been installed in a rack or cabinet, connected to your networks, and powered on.
Network links, IP addresses, and port remapping (if necessary) have been configured for the appliance using the StorageGRID Appliance Installer.
The primary Admin Node for the StorageGRID grid has been deployed.
All Grid Network subnets listed on the IP Configuration page of the StorageGRID Appliance Installer have been defined in the Grid Network Subnet List on the primary Admin Node.

For instructions for completing these prerequisite tasks, see the installation and maintenance instructions for your appliance.

You have a service laptop with a supported web browser.
You know one of the IP addresses assigned to the appliance's compute controller. You can use the IP address for any attached StorageGRID network.

About this task

To install StorageGRID on an appliance Storage Node:

You specify or confirm the IP address of the primary Admin Node and the name of the Storage Node.
You start the installation and wait as volumes are configured and the software is installed.
Partway through the appliance installation tasks, the installation pauses. To resume the installation, you sign into the Grid Manager, approve all grid nodes, and complete the StorageGRID installation process.

Note: If you need to deploy multiple StorageGRID appliance Storage Nodes at one time, you can automate the installation process by using the configure-sga.py Appliance Installation Script.

Steps

Open a browser, and enter one of the IP addresses for the compute controller.
https://Controller_IP:8443

The StorageGRID Appliance Installer Home page appears.
In the Primary Admin Node connection section, determine whether you need to specify the IP address for the primary Admin Node.
If you have previously installed other nodes in this data center, the StorageGRID Appliance Installer can discover this IP address automatically, assuming the primary Admin Node, or at least one other grid node with ADMIN_IP configured, is present on the same subnet.

If this IP address is not shown or you need to change it, specify the address:

Option	Description
Manual IP entry	Unselect the Enable Admin Node discovery check box. Enter the IP address manually. Click Save. Wait for the connection state for the new IP address to become ready.
Automatic discovery of all connected primary Admin Nodes	Select the Enable Admin Node discovery check box. Wait for the list of discovered IP addresses to be displayed. Select the primary Admin Node for the grid where this appliance Storage Node will be deployed. Click Save. Wait for the connection state for the new IP address to become ready.

In the Node name field, enter the name you want to use for this Storage Node, and click Save.
The node name is assigned to this Storage Node in the StorageGRID system. It is shown on the Grid Nodes page in the Grid Manager. If required, you can change the name when you approve the node.
In the Installation section, confirm that the current state is "Ready to start installation of node name into grid with Primary Admin Node admin_ip" and that the Start Installation button is enabled.
If the Start Installation button is not enabled, you might need to change the network configuration or port settings. For instructions, see the installation and maintenance instructions for your appliance.
From the StorageGRID Appliance Installer home page, click Start Installation.

The Current state changes to "Installation is in progress," and the Monitor Installation page is displayed.

Note: If you need to access the Monitor Installation page manually, click Monitor Installation from the menu bar.
If your grid includes multiple StorageGRID appliance Storage Nodes, repeat these steps for each appliance.
Note: If you need to deploy multiple StorageGRID appliance Storage Nodes at one time, you can automate the installation process by using the configure-sga.py appliance installation script.