Configuring proxy settings

To send AutoSupport messages through a non-transparent proxy, you can configure your proxy server settings using the NAS Bridge user interface.

Before you begin

About this task

You can configure the settings for a single proxy.

Steps

  1. Select Configuration > Proxy Settings.
    The Proxy Settings page appears.
    Proxy Settings for AutoSupport
  2. Enter the hostname or IP address of the proxy server.
  3. Enter the port used to connect to the proxy server.
  4. Click Save.
    After the proxy is saved, the proxy server between the NAS Bridge and technical support is configured.
    Note: Proxy changes can take up to 10 minutes to take effect.
  5. To remove the proxy settings from NAS Bridge, click Clear.