Viewing status indicators on the SG1000

The SG1000 includes indicators that help you determine the status of the SG1000 controller and the two SSDs.

Controller indicators and buttons


Front Indicators - SG1000
  Display State Description
1 Power button Blue The controller is powered on.
Off The controller is powered off.
2 Reset button Not applicable Use this button to perform a hard reset of the controller.
3 Identify button Blue, blinking

Identifies the controller in the cabinet or rack.

This button can be set to Blink, On (Solid), or Off.

Blue, solid
Off The controller is not visually identifiable in the cabinet or rack.
4 Alarm LED Amber, solid An error has occurred.
Note: To view the boot-up and error codes, you must access the BMC interface.
Off No errors are present.

General boot-up codes

During boot-up or after a hard reset of the SG1000, the following occurs:
  1. The baseboard management controller (BMC) logs codes for the boot-up sequence, including any errors that occur.
  2. The power button lights up.
  3. If any errors occur during boot-up, the alarm LED lights up.

    To view the boot-up and error codes, you must access the BMC interface.

SSD indicators


SSD Indicators
LED Display State Description
1 Drive status/fault Blue, solid Drive is online
Amber, blinking Drive failure
Off Slot is empty
2 Drive active Blue, blinking Drive is being accessed