SG6000-CN: Installing into a cabinet or rack

You must install a set of rails for the SG6000-CN controller in your cabinet or rack, and then slide the controller onto the rails.

Before you begin

Steps

  1. Carefully follow the instructions for the rail kit to install the rails in your cabinet or rack.
  2. On the two rails installed in the cabinet or rack, extend the movable parts of the rails until you hear a click.

    SG6000 Rails
  3. Insert the SG6000-CN controller into the rails.
  4. Slide the controller into the cabinet or rack.

    When you cannot move the controller any further, pull the blue latches on both sides of the chassis to slide the controller all the way in.


    SG6000 Sliding on Rails
    Note: Do not attach the front bezel until after you power on the controller.