Skip to main content
SANtricity commands

Reset storage array SOC baseline

Contributors netapp-driley

The reset storageArray SOCBaseline command resets the baseline for all switch-on-a-chip (SOC) devices that are accessed through the controllers.

Supported Arrays

This command applies to any individual storage array, including the E4000, E2700, E5600, E2800, E5700, EF600 and EF300 arrays, as long as all SMcli packages are installed.

Roles

To execute this command on an E4000, E2800, E5700, EF600, or EF300 storage array, you must have the Storage Admin role.

Context

This command resets the baseline by setting all of the SOC counts to 0. This command is valid only for Fibre Channel devices in an arbitrated loop topology.

Syntax

reset storageArray SOCBaseline

Parameters

None.

Minimum firmware level

6.16