Specify the Email (SMTP) delivery method

12/13/2024 Contributors

The set storageArray autoSupport deliveryMethod command sets up the delivery method for sending AutoSupport messages to email (SMTP).

Supported Arrays

This command applies to an individual E4000, E2800, E5700, EF600 or EF300 storage array. It does not operate on E2700 or E5600 storage arrays.

Roles

To execute this command on an E4000, E2800, E5700, EF600, or EF300 storage array, you must have the Storage Admin or Support Admin role.

Syntax

set storageArray autoSupport deliveryMethod=email
mailRelayServer="serverAddress" senderEmail="emailAddress" destinationAddress="destination1@example.com" destinationAddress="destination2@example.com";

Parameters

Parameter Description

deliveryMethod

Allows the user to specify the delivery method for AutoSupport collection. Valid choices are:

email
HTTPS

If the email method is configured, then the AutoSupport OnDemand and Remote Diagnostics will be disabled.

mailRelayServer

Allows the user to specify the mail relay server for the AutoSupport collection.

senderEmail

Allows the user to specify send email address for the AutoSupport collection.

destinationAddress

Email address where AutoSupport dispatches will be sent. This parameter may be provided multiple times to allow dispatches to be sent to multiple addresses.

Examples

SMcli -n Array1 -c "set storageArray autoSupportConfig deliveryMethod=email mailRelayServer=\"mailserver.company.com\" senderEmail=\"user@company.com\";"

SMcli completed successfully.

Verification

Send a test message using the start storageArray autoSupport deliveryTest command to verify that your delivery methods are set up correctly.

Minimum Firmware Level

8.40