Skip to main content
SANtricity commands

Start storage array iSNS server refresh

Contributors netapp-driley
PDFs

The start storageArray isnsServerRefresh command initiates a refresh of the network address information for the iSNS server.

Supported Arrays

This command applies to any individual storage array, including the E4000, E2700, E5600, E2800, E5700, EF600 and EF300 arrays, as long as all SMcli packages are installed.

Roles

To execute this command on an E4000, E2800, E5700, EF600, or EF300 storage array, you must have the Storage Admin role.

Context

If the DHCP server is marginal or unresponsive, the refresh operation can take from two to three minutes to complete.

Note

This command is for IPv4 only.

Syntax

start storageArray isnsServerRefresh

Parameter

None.

Notes

If you used the set storageArray isnsIPv4ConfigurationMethod command to set the configuration but did not set the configuration to DHCP, running the start storageArray isnsServerRefresh returns an error.

Minimum firmware level

7.10